Default settings of the Ubiquiti Networks ER-X
Here you can find the default IP address and the username and password for the user interface of the Ubiquiti Networks ER-X Gigabit Ethernet router. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.
Login data for the user interface
- IP address:
Access to the user interface
Accessing the user interface is necessary when you want to change the router configuration. For the Ubiquiti Networks ER-X, you have to do the following steps for access:
- Switch on router
- Connect the device via network cable with the router
- Open web browser
- Enter IP address in the address bar and then confirm with ‘Enter’ key
- Enter username as well as password in the login form and confirm
Reset default settings
Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.
Execute hardware reset
To reset the Ubiquiti Networks ER-X to its default settings, you have to do the following steps:
- Switch on router
- For at least 10 seconds, press the RESET button
- Restart of the device is automatically executed
- Restoration of standard settings is finished
Execute software reset
With the Ubiquiti Networks ER-X, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.
After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.