routerdefaults.ORG IP addresses, usernames, passwords, and more

Default settings of the Billion BiPAC 8900AX-2400

Here you can find the default IP address and the username and password for the user interface of the Billion BiPAC 8900AX-2400 Wireless 2400Mbps 3G/4G LTE router. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.1.254
Username:
admin
Password:
admin

Preconfigured Wi-Fi settings

No wireless networks are preconfigured for this device.

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Billion BiPAC 8900AX-2400, you have to do the following steps for access:

  1. Put router into operation
  2. Establish a connection between the device and the router via network cable or Wi-Fi*
  3. Open browser
  4. Insert IP address in the address bar and confirm with ‘Enter’ button
  5. Enter username and password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Billion BiPAC 8900AX-2400 to its default settings, you have to do the following steps:

  1. Turn on router
  2. Press Reset button for at least 5 seconds
  3. Device restarts automatically
  4. Default settings have been restored

Execute software reset

With the Billion BiPAC 8900AX-2400, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.