Login data for the user interface
- IP address:
Access to the user interface
Accessing the user interface is necessary when you want to change the router configuration. For the DrayTek Vigor110, you have to do the following steps for access:
- Put router into operation
- Set up a connection between the device and the router via network cable
- Open browser
- Enter IP address in the address bar and then confirm with ‘Enter’ key
- Enter password in the open user interface and confirm again
Reset default settings
Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.
Execute hardware reset
To reset the DrayTek Vigor110 to its default settings, you have to do the following steps:
- Turn on router
- Press Reset button and hold for at least 10 seconds
- Device is automatically restarted
- Default settings have been restored
Execute software reset
With the DrayTek Vigor110, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.
After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.