routerdefaults.ORG IP addresses, usernames, passwords, and more

Default settings of the Belkin F7D5301

Here you can find the default IP address and the predefined access data for the user interface of the F7D5301 Connect N150 Wireless router of Belkin. This site also contains information about the preconfigured Wi-Fi settings of the device. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.2.1 (or http://router/)
Username:
<blank>
Password:
<blank>

Preconfigured Wi-Fi settings

SSID:
on an information card that comes with the router
Password:
on an information card that comes with the router

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Belkin F7D5301, you have to do the following steps for access:

  1. Switch on router
  2. Connect the device via Wi-Fi* or a network cable with the router
  3. Start web browser
  4. Insert URL or IP address into the address bar and confirm with ‘Enter’ key
  5. Enter password in the open interface and confirm once more

This router can also be configured with the provided software.

* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Belkin F7D5301 to its default settings, you have to do the following steps:

  1. Switch on router
  2. For at least 10 seconds, press the Reset button
  3. Device restarts automatically
  4. Restoration of standard settings is finished

After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.